Matching Chrome 3-Piece Shave Stand Setup Guide

Quick answer

Assembling your Matching Chrome 3-Piece Shave Stand takes under a minute: screw the chrome-plated brass arms into the weighted base, then hang your razor and brush for a tidy, counter-friendly setup.

Step-by-step setup guide

1. Unpack and identify the parts: The stand arrives as three pieces: a weighted base, a vertical post, and a horizontal arm with two hooks. Check that the threaded end of the post matches the base's center hole. Common mistake: trying to force the post into the base without aligning the threads. Hand-tighten only—overtightening can strip the brass threads.
2. Assemble the post and base: Screw the vertical post into the base by turning clockwise until snug. The base is heavy enough to hold the post steady without tools. Checkpoint: if the post wobbles, unscrew and re-seat it. A slight gap between the post and base is normal—do not force it further.
3. Attach the horizontal arm: Slide the horizontal arm onto the top of the post and tighten the small set screw (if included) or simply press it into the friction-fit collar. The arm should sit level. Common mistake: mounting the arm upside down. The longer hook is designed for your razor, the shorter one for your brush.
4. Place the stand on your counter: Set the assembled stand on a dry, flat surface away from the direct splash of the faucet. The rubber or felt pads on the base bottom prevent sliding and protect your countertop. Checkpoint: if the stand slides, wipe the base pads clean—moisture or soap residue reduces grip.
5. Hang your razor and brush: Place your Rockwell razor (2C, 6C, or Model T) on the longer hook with the head facing down so water drains. Hang your brush on the shorter hook with bristles pointing down. Common mistake: hanging the razor by the handle rather than the head. The head hook is designed to hold the weight evenly and prevent scratches.

Product facts

• Matching Chrome 3-Piece Shave Stand: Elegantly designed for maximum counter-top appeal with a substantially weighted base for reliability. Made from chrome-plated brass. Built to hold a Rockwell 2C, 6C or Model T Razor. The weighted base prevents the stand from tipping when you lift your razor, and chrome-plated brass resists rust far better than cheaper materials in a steamy bathroom.